Picture b4 I took my motor to the shop


No more 2.SLOW

In with the new.



The pics are a little blurry but I was using a camers phone. All I need to do now is wire it and figure out what imma do about a driveshaft I hope the front half of a S13 driveshaft will work. I cut out my trans tunnel for S13 trans and with a short throw in will work you just need to notch the inside of the shiftboot frame and use a cloth or thin leather shift boot. I will get those pics up when I work on it again.

That looks like a JGS Precision exhaust mani

Very naassty!! Looks graet keep us updated.

Yep. Cast... not expensive and not gonna crack.Haha

Has anyone had problems closin the hood after the swap? I need about an inch more of clearence. Would hood spacers do the trick?

Appearantley going to a MKII hood does the trick.

just use some longer bolts and fender washers on the hinges

You can just take off the black cover on the bottom of the hood, and cut out some of the hood skeleton to get more clearance. I think it might be just enough.

yeah, this is how my setup is, and it closes. hood spacers help a little bit. but, not as much as the cutting, because its the front of the engine thats touching it. although ill also add that i have problems getting my hood latch to release, maybe its related?

Did any KA owners have to swap the throttle cable from S13? My stock one is about 1 1/4 in. too short.

i ghetto rigged mine with some extra wire...