if i do the ka bell housing swap on my 88 ca20e tranny will i be able to use ka flywheel pressure plate and clutch or do i have to use stock stuff

if you do the ka bellhouse on the ca20 transmission gear box you use all the ka clutch, flywheel, pressure plate everything. the ka is physicaly bigger than the ca stuff

i dont think the ca20e crank has the same bolt pattern as the ka i believe the ka is bigger.... correct me if im wrong

well i'm useing the ka bellhouse on a ca transmission gearbox on the ka motor, with all new ka clutch and flywheel, the ca bellhouse is tiny compared to the ka. the ka transmission will not bolt to the ca block the size is way off the starter is in a diffrent place. i dont know about the crank bolts being bigger or smaller but seein as everything else is diffrent i would imagain that would be too

k never mind i thought you had the swap the other way....

good cause im wanting to do u 6 puck unsprung with a light weight flywheel

I believe the clutch discs are the same, but that's it.